Contents
- Older Kit Components
- Connecting the Reset Button
- Connecting the Serial Programmer
- Connecting the USB Programmer (One-Piece Cable)
- Connecting the USB Programmer (Single Header Board)
- Connecting the Front Sensor (Digital Version)
- Programming the Front Sensor (Digital Version)
- Connecting the Down Sensors (Flat Flex Connections)
- Connecting the Down Sensors (Soldered Ribbon Cables)
- Building the ATMega Board (Single Header USB Programmer)
- Connecting the GPS to Your Computer (Single Header USB Board)
- Connecting the GPS to the Chip (Single Header USB Board)
|
||
|
Older Kit Components This tutorial provides instructions for connecting and programming certain discontinued hardware components that were included with early versions of the Machine Science breadboard kits. These parts, some of which are shown below, include:
 Figure 1. Discontinued components.
|
